JOB 735 LAB delivers 330 Amp direct current (DC). The power supply voltage is three-phase 230 / 400 Volt with autosetting.
JOB 735 LAB offers 3 welding processes always at hand: MIG/MAG, MMA, and TIG LIFT.
In MIG/MAG mode, Job 735 LAB is perfect for welding on steel, stainless steel, aluminum, and for using wire for brazing and flux cored.
The Synergic control is extremely effective. All the main welding parameters are connected and act in a combined way to obtain a welding quality usually found in more sophisticated products.
The control panel is very simple to facilitate use in synergic and manual modes. The machine is pre-installed with a standard package of over 20 programs. An SD card can be used to update the software.
The color graphic control panel is easy to use and can be used in either simple or advanced modes. The machine has a pre-installed standard package of over 20 programs for different types of material, diameter, and gas. Additionally, the software can be updated through an SD card.
The control panel has multiple welding parameters and functions available to optimize the work, including Hot start, Crater filler, and Root Pass.
The TIG LIFT welding process, using a torch with a tap to control the protective gas, allows for minute processing on mild steel and stainless steel sheets of small thickness.
In TIG welding with LIFT arc striking, the tungsten electrode is placed on the surface to be welded and by lifting it slowly to strike the welding arc. The passage of low intensity current allows not to ruin the electrode while the welding machine progressively increases the amperage.
In electrode welding MMA Job 735 LAB can be used with rutile and basic electrodes from 1.6 to 5.0 mm in diameter with excellent ignition properties and a stable arc. It is suitable for welding of mild steel and stainless steel.
