JOB 222 PD LAB is the ideal welding machine for the craftsman and professional who needs different welding processes in a single installation:MIG/MAG, FLUX, MMA, and TIG LIFT.
JOB 222 PD LAB delivers 220 Amp direct current (DC). The power supply voltage is single-phase 230 Volt. It can be connected to a motor generator (see technical data table).
MIG/MAG welding can be done using PULSED / DOUBLE PULSED methods for steel, stainless steel, aluminum, and wire for brazing.
Low-thickness aluminum and stainless steel can be achieved with exceptional results using MIG pulsed and double-pulsed.
The Synergic control is extremely effective. All the main welding parameters are connected and act in a combined way to obtain a welding quality usually found in more sophisticated products.
The change of polarity allows you to use a NO GAS cored wire. The cored wire has a substance inside that provides gaseous protection, making welding very simple without the need for a gas cylinder, particularly when working outdoors.
The control panel is very simple to facilitate use in synergic and manual modes. The machine is pre-installed with a standard package of over 20 programs. An SD card can be used to update the software.
The color graphic control panel is easy to use and can be used in either simple or advanced modes. The machine has a pre-installed standard package of over 20 programs for different types of material, diameter, and gas. Additionally, the software can be updated through an SD card.
It houses wire spools with a diameter of 200 – 300 mm.
The TIG LIFT welding process, using a torch with a tap to control the protective gas, allows for minute processing on mild steel and stainless steel sheets of small thickness.
In TIG welding with LIFT arc striking, the tungsten electrode is placed on the surface to be welded and by lifting it slowly to strike the welding arc.
